MicronPC CM900 Betriebsanweisung

CM900 Monitor User’s Guide

10Accessing the Adjustment Controls The following list explains how to access and use the adjustment controls appearing in the On Screen Display (OS

11Adjusting the Picture The table below describes the functional control icons that appear on the OSD menu. Table 2: Functional Control Icons Functi

12Table 2: Functional Control Icons (Continued) 6500°K/9300°K (Color Temperature) 6500 9300 The OSD menu presents two different color sets on the sc

13MONITOR DRIVERS During normal operation, your system will automatically detect your monitor, and Plug and Play drivers will automatically be instal

14Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. These capabilities allo

15Table 3: Troubleshooting Monitor Issues (Continued) The picture is fuzzy. • Adjust the contrast and brightness controls. • Make sure there are no

16APPENDIX B — FACTORY PRESET TIMING Table 4: Factory Preset Timing Standard Resolution Horizontal Frequency Vertical Frequency DOS 720 x 400

17APPENDIX C — CONNECTOR PIN ASSIGNMENT 1 561011 15 Figure 6: 15-pin Color Display Signal Cable Table 5: Video Cable Pin Assignments Pin # Descript

18Table 6: Monitor Specifications (Continued) Dot Clock • 200 MHz Recommended Viewing Resolutions • Minimum: 800 x 600 @ 85 Hz • Nominal: 1280 x 1

19APPENDIX E — FCC NOTICE FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) This equipment has been tested and

2TABLE OF CONTENTS Monitor User’s Guide... 3 Packing List ...

3MONITOR USER’S GUIDE This user’s guide provides important information about operating your monitor. Before using the monitor, please read the guide

4• The monitor must only be connected to the AC power source as indicated on the label. If you are unsure of the type of AC power available, ask you

5SETUP INSTRUCTIONS This section provides information for attaching the swivel base to your monitor and for using the power cord and video cable. Swi

6Adjusting the Monitor’s Viewing Angle • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s a

7To connect the power cord to your monitor and a power source, use the following instructions: Caution: If the AC outlet is not grounded (with three

8OPERATING INSTRUCTIONS The following sections provide information about operating and adjusting your monitor. General Instructions To turn on the mo

9 5 4 6 Figure 4: Control Buttons Table 1: Control Buttons Descriptions Feature Description 1 Exit Press this button to close the On Screen Displ